My Profile

Keep Up to Date:
Blog RSS
Blog
Forum RSS
Forum

heel

...ce and flat runout, it's time to learn how to stop. You do this by turning either onto your toe-side or heel-side edge. To stop with a toe-side turn while you are on your descent, steer by twisting ...
...ce snowboarders are riding sideways on their boards, they have a blind spot when they turn toward their heels.   ...
...ing a board with a width of 250. I wear size 11 boots and when I strap in my boots overhang on both the heel and toe side. I have my bindingss at 15/15 degrees and 21 inches apart O.C. If I have ...
...step up to a really wide board, which I don`t neccesarily want. My current board just has too much toe/heel drag unless i run some crazy angles. thanks Matt...
...55? and also i found that my boots are 1.5cm over the edge on both sides, would that create a large toe/heel drag?...
...nd momentum? (my biggest problem in the past was having a very difficult time getting into both toe and heel-edge clean carves after gaining a lot of forward momentum and speed) *Where can I go to fin...
... use to the controls this time. I found out im really good at the toeside turns and butters but not the heelside. It just seems tough to try to brake/slowdown heelside but it can be done. So pretty m...
... feel a bit cramped in the toebox and seem a bit snug side-to-side, but size 10 gives me way too much heel lift. On the boots that feel a bit snug, I get numb middle toes after about 10 - 15 minute...
...etting back on the mountain, but I am a little bit concerned that I`m going to find it hard to do hard heelside turns without a highback. These boots feel about as stiff as my previous boots, but I ...
...ts. I've only been able to try on the vans encore boa boots and found it quite comfortable with minimal heel lift however no stores around me carry dc boots so as to test out the difference. Has any o...
...ift forward when strapping in on the lift (I do this by hooking my toe under the toe strap, pushing my heel down the high back, fixing ankle strap, tightening toe strap) A brief note on the flex:...
...ed apart on the think plastic base that wraps around the back of your foot, just above the back of the heel. It`s pretty thick plastic, so I think it will glue pretty well, if I knew of some good ...
...adapter plate they gave me that I can mount the binding toward the toe edge of the board or toward the heel edge. Any advice on a preference? I know I shouldn`t overhang too much on either side. I ...
...e response ankle straps` design? I love my Northwave boots, but after two seasons I`m starting to get heel lift problems. Is the Nike system effective minimizing heel lift? Overall, how do you like...
...et of ice is more like it.) After about 6 runs I was really getting frustrated because I just had no heel-side control, so I decided to bite the bullet, drove down to the shop recommended to me by...
...ommendations would be welcome. The problem is that my ankle is fairly narrow so I always get a lot of heel movement. In order to have good control over the board I then need to tighten my bindings ...
We went out to the cabin and tow roped on the back of rhinos and 4 wheelers, we got em up to about 40 and went of kickers and such, we had a blast but i have to say, combinig snowboards and atvs, its
...ready got some thicker snowboarding socks but it still comes up when i try to carve. What about those heel strap things that go around your boot? thanks...
...'s weird tho is I usually cant initate a jump unless i'm on my toe side edge, is there any way to do it heelside? Also when I land sometimes i'll land on an edge and fall. Also whats the best way to ...
... needs to be used.. One`s on the nose with a little bit of a bump and one is on the tail close to the heelside edge that has about 3/4" along the edge and 1/4" from the edge of the top sheet pullin...
...e no idea what you call it. Originally I was told it was a method. Is a method when you grab onto the heel of the board? What I did was similar but the board came up further and I grabbed the toe e...
...ike they must be to stay in control, but their board sure looks flat on the snow. Every time I do a heel-side turn (I ride goofy) my board wants to slow me WAY down (back foot travels forward a l...
...h to really appreciate the good snow out west. I have some old Switch step-ins (love `em), some hard Heelside boots, and a Ride board, a Fifty-One-Fifty. I`m not positive about the board being a ...
If I am carving on a steep slope I noticed that my board starts 'hopping' when Im on my heel edge. That is it grabs and releases its grip over and over, however it doesnt do this when Im on the toe ed
...ave a K2 clicker binding/boot system which I'm not too happy with because when I do a toe-side turn, my heel comes up too high; seems like I have to exert a lot of pressure to make the turn. I'm looki...
...d this: Barbell Calf raise(hold the bar on your back, stand on a block [gatrocnemius] of wood w/ your heels hanging off, lower as far as you can, and then go up on your toes as high as you can. repe...
... But, the thing is....... ......I tried the pipe (beginer) last year. Was doing ok untill I caught my heelside edge. I severly brused my tailbone and slightly sprained my wrist. So for the rest of t...
Page: 1

Copyright © 2006 - Dec 2008 Snowboard Gang